Page 1 of 1
Another Problem :/
Posted: Mon Jun 28, 2010 4:49 pm
by shire99
So I have a macro set (not to loop) to target a recall scroll by type and wait for target. However, whenever i punch the hotkey for this macro, the cursor never comes up, although it does say that the ''flee'' macro has finished. It finally comes up on the third try. WTF?
Re: Another Problem :/
Posted: Mon Jun 28, 2010 5:58 pm
by Populus
Wait for target usually lags up for me. Try inserting a pause instead of the Wait for target.
Re: Another Problem :/
Posted: Mon Jun 28, 2010 6:00 pm
by Roser
Read this
http://forum.uosecondage.com/viewtopic.php?f=11&t=19972
Fixed.
If not, add a bigger pause in your macro.
Re: Another Problem :/
Posted: Thu Jul 01, 2010 7:57 pm
by Joueur Moyen
Are you targeting a rune in the macro?
Re: Another Problem :/
Posted: Fri Jul 02, 2010 12:06 pm
by shire99
No but I will now because last night I got pked, I almost got away. I saw the cursor come up. was about an inch away from the rune before I died... A better macro would have been the difference between life and death. You live and you learn I guess.
Re: Another Problem :/
Posted: Fri Jul 02, 2010 12:33 pm
by Joueur Moyen
shire99 wrote:No but I will now because last night I got pked, I almost got away. I saw the cursor come up. was about an inch away from the rune before I died... A better macro would have been the difference between life and death. You live and you learn I guess.
Just make sure you have the rune with you that the macro targets. If you lose the rune, or change to a different rune, then set the Absolute Target in the macro to the new rune. (Right click on Absolute Target in the macro and select Re-target to set a new rune as the target.)